Retro-Active Reset
Each of the two trip odometers has a feature called
retro-active reset. This feature can be used to set either
(or both) trip odometer(s) to the number of miles
(kilometers) driven since the ignition was last turned on.
This can be used
if
you forget to reset your trip
odometer at the beginning of a trip. To use the
retro-active reset feature, press and hold the tripheset
button for at least three seconds. The trip odometer
will then display the number of miles (kilometers) driven
since the ignition was last turned on and you began
driving.
(If
you use the retro-active reset feature
after you have started the vehicle, but before you begirl
moving, the display will show the number of miles
(kilometers) you drove during the last ignition cycle.)
Once you begin driving, the trip odometer will
accumulate mileage. For example,
if
you have driven
5.0
miles (8.0 km) since you started your vehicle,
and then activate the retro-active reset feature, the
display will show
5.0
miles
(8.0
km).
As
you drive, the
display
will
then increase to
5.1
miles (8.2 km). 5.2 miles
(8.4
km), etc. Only the trip odometer that is displayed
will be affected by the retro-active reset
so
that both trip
odometers can be used separately.
Tachometer
2
RPM
x
1000
1
---
MESSAGE
CENTER
/
Your vehicle may have a tachometer that displays the
engine speed
in
revolutions per minute (rpm).
Notice;
Do
not operate the engine with the
tacnometer in ine rea area,
or engine
aamage
may occur.
3-39
To Next Page
Loading...
Need help?
General
