License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the
license plate lamps.
2. Turn and pull the license plate lamp toward you
through the opening.
3. Turn the bulb socket counterclockwise and pull the
bulb straight out of the socket.
4. Install the new bulb.
5. Push the bulb straight into the socket and turn
clockwise to reinstall.
6. Push and turn the license plate lamp away from
you through the opening.
7. Reinstall the two screws holding the license
plate lamp.
Replacement Bulbs
Exterior Lamps Bulb Number
Back-Up Lamps 921
Center High-Mounted
Stoplamp (CHMSL)
912
Front Parking/Turn Signal Lamps 3157KX
Halogen Headlamps,
High/Low-Beam
9007 LL
License Plate Lamp and
Sidemarker
194
Stoplamp, Taillamp and
Turn Signal Lamps
3057KX
For replacement bulbs not listed here, contact your
dealer/retailer.
6-55
To Next Page
Loading...
Need help?
General
