Chevrolet Spark Owner Manual - 2013 - 1st - 5/2/12
3-14 Seats and Restraints
To install the adjustable comfort
guide to the seatback and the
safety belt:
1. Locate the anchor loop on the
rear outboard seatback, near
the top.
2. Attach the adjustable comfort
guide to the anchor loop by
threading the hook through
the loop.
3. Place the guide over the belt,
and insert the two edges of the
belt into the slots of the guide.
4. Be sure that the belt is not
twisted and it lies flat. The
elastic cord must be under the
belt and the guide on top.
5. The elastic cord on the comfort
guide is adjustable. You can
make it longer or shorter by
squeezing both ends of the
plastic adjuster and pulling on
the elastic cord or the guide.
6. Adjust the guide so the shoulder
portion of the belt is on the
shoulder and not falling off of it.
The belt should be close to, but
not contacting, the neck.
To Next Page
Loading...
