~
I
~
Aftetlhe<TENIP
lightisout
or
the gage needle is
out
of warning
zone, resume driving
at
a IeCluced speed.
,H
the light does not come
,back
on
in
aboutten
minutes, return to normal driving.
JACKING
CAUTION
In order to reduce, the chance
of
personal injury:
1.
Follow jacking and.stowage instructions.
2.
Use jack only when changing wheels.
3. Never get beneath the vehicle when using jack.
4.
. Do not.start
or
run engine while vehicle is on jack.
Instructions
• Park
on
level surface and set parking brake firmly.
• Set automatic, translllissionin "Park" (manual transmission in
"Reverse,,).
• Activate hazard warning flasher.
• Remove wheel opening cover, if equipped.
•
Loosen,but
do not
remOVe,
wheel nuts by rotating wrench
counterclockwise .
• • With column seated
in
base,'
and lever
in
"up" position, insert jack
hook in
bumper.slot.
• .
B~se
must
sit
flat
with
top
of
column angled slightly away from
vehicle.
(See illustration)
• Operate jack with slow,smooth motion.
• Raise vehicle so tire
just
clears
SUrface.
Flexible body panels
may temporarily bend during jacking.
•
ReplaQe
wheel' and slightly tighten wheel. nuts
.•
Wheel must be
seated
on.
hub.
• Place
jack
lever in "down"position. Lower vehicle and fully
tighten.
wheell'utsby
applying clockwise pressure near, end of
wrench.
'
WheeLnut torque should
be
set to specifications shown below.
Wheel.' Nut Torque Caution
'
CAUTION:
As soon '
as
possible
after
Installing
a wheel--
and
at the
intervals shown
'on
the chart in the Maintenance Schedule folder--have
amechan1c.tjghten wheel
nuts
With a torque wrench
to
80
foot-pounds
('W8 • newton-metres)
on~t~ndard'
",heel and,
90
foot-pounds (122
newton-melres)on
,aluminum wheel. Wheel
nuts
ShOl.lld. be tightened
alternately.
lind
evenly
to
the
correottorque.
Improperly tightened wheel
outscouldeventuallyallowlhe
wheel
to.
come
off
while the vehicle
is
in
motion,
PO'$ib,ycau~ing}IOS$Of
control. (Also see Caution
in/the
Service
lind
.Maintenanc~
s.~cti.onof
this manual regarding
the
danger
of
milling metric
and
customary fasteners.)
3
:-
5
To Next Page
Loading...
Need help?
General
