Chicago Electric 69274 User Manual (English)

Questions and Answers:

E
elizabeth12Jul 31, 2025
What to do if my Chicago Electric 69274 Rotary Hammer won't start?
- J
  Jason ReidJul 31, 2025
  If your Chicago Electric Rotary Hammer won't start, here's what to check: 1. Make sure the power cord is properly plugged in. 2. Verify that the outlet has power. If not, check the circuit breaker, ensuring the circuit's capacity is adequate and isn't overloaded. 3. If the tool has a thermal reset breaker, turn it off, let it cool, and then press the reset button. 4. If none of these steps work, internal damage or wear may be the issue. In this case, have a qualified technician service the tool.
A
Aaron AlvarezAug 6, 2025
Why is my Chicago Electric 69274 overheating?
- S
  sharoncoxAug 6, 2025
  There are several reasons why your Chicago Electric Rotary Hammer might be overheating: 1. You might be forcing the tool to work too quickly. Allow it to work at its own pace. 2. The accessory might be misaligned. Check and correct its alignment. 3. The accessory could be dull or damaged. Keep cutting accessories sharp and replace them when necessary. 4. The motor housing vents might be blocked. Wear safety goggles and a dust mask/respirator, then use compressed air to blow dust out of the motor. 5. A long or small diameter extension cord could be straining the motor. Try eliminating the extension cord or using one with the correct diameter for its length and load.
K
Kara BellAug 12, 2025
Why is my Chicago Electric 69274 operating slowly?
- R
  Robert RamirezAug 13, 2025
  If your Chicago Electric Rotary Hammer is operating slowly, it could be due to an extension cord that is either too long or has too small of a diameter. Try eliminating the extension cord. If you must use one, ensure it has the proper diameter for its length and the load.
M
Mr. John JohnsonAug 18, 2025
What to do if my Chicago Electric Rotary Hammer's performance decreases over time?
- T
  Tiffany HansonAug 18, 2025
  If the performance of your Chicago Electric Rotary Hammer decreases over time: 1. Check if the accessory is dull or damaged. Keep cutting accessories sharp, and replace them as needed. 2. The carbon brushes may be worn or damaged. Have a qualified technician replace them.
C
Crystal BurkeAug 25, 2025
Why is my Chicago Electric 69274 Rotary Hammer making excessive noise?
- C
  Cheyenne DaltonAug 25, 2025
  Excessive noise or rattling in your Chicago Electric Rotary Hammer is likely due to internal damage or wear, such as with the carbon brushes or bearings. Have a technician service the tool.

Chicago Electric 69274 Specifications

General

Drilling capacity - Steel	1/2 in.
Voltage	120 V
Impacts Per Minute (IPM)	3900 BPM
No Load Speed (RPM)	800 RPM
Drilling capacity - Concrete	1-1/8 in.
Drilling capacity - Wood	1-1/2 in.
No Load Speed	800 RPM
Impact Rate	3900 BPM
Chuck Type	SDS-Plus
Max Drilling Capacity (Concrete)	1-1/8 inch
Max Drilling Capacity (Wood)	1-1/2 in.