Chicago Electric 91938 User Manual (English)

Other manuals for Chicago Electric 91938

Operating Instructions17 pages

Set Up And Operating Instructions16 pages

Questions and Answers:

T
Timothy TaylorAug 12, 2025
What to do if my Chicago Electric 91938 Saw will not start?
- S
  steven92Aug 12, 2025
  If your Chicago Electric Saw won't start, here are a few things to check: 1. Make sure the cord is properly plugged in. 2. Verify that the outlet has power. If not, turn off the tool and check the circuit breaker. If the breaker is tripped, ensure the circuit has the correct capacity and isn't overloaded. 3. If the tool has a thermal reset breaker, turn it off, let it cool down, and then press the reset button. 4. If none of these steps work, there may be internal damage or wear, and you should have a technician service the tool.
S
Susan DodsonAug 16, 2025
Why is my Chicago Electric 91938 overheating?
- G
  grace27Aug 16, 2025
  If your Chicago Electric Saw is overheating, consider the following: 1. Allow the machine to work at its own pace, avoiding forcing it to work too fast. 2. Check and correct the alignment of the accessory to the fence and/or table. 3. Clean blocked motor housing vents using compressed air while wearing ANSI-approved safety goggles and a NIOSH-approved dust mask/respirator. 4. Avoid using an extension cord. If one is necessary, ensure it has the proper diameter for its length and load.
R
Richard YoungAug 20, 2025
How to fix a Chicago Electric Saw that operates slowly?
- C
  Catherine YoungAug 20, 2025
  If your Chicago Electric Saw is operating slowly, the extension cord might be too long or the wire size too small. Try eliminating the extension cord. If you need one, use a shorter, heavier gauge cord.
C
Cory DavisAug 25, 2025
What to do if Chicago Electric 91938 Saw performance decreases over time?
- G
  George BradshawAug 25, 2025
  If the performance of your Chicago Electric Saw decreases over time, it could be due to worn or damaged carbon brushes. It is suggested to have a qualified technician replace the brushes.
V
Victoria TaylorAug 27, 2025
Why is my Chicago Electric 91938 making excessive noise?
- T
  Timothy GarzaAug 27, 2025
  Excessive noise or rattling in your Chicago Electric Saw usually indicates internal damage or wear. It's recommended to have a technician service the tool.
R
Ryan KennedyAug 31, 2025
Why is the performance of my Chicago Electric 91938 Saw decreasing?
- W
  Wendy WilsonAug 31, 2025
  If your Chicago Electric Saw's performance is decreasing over time, the carbon brushes may be worn or damaged. A qualified technician should replace them.
J
Jose MillerSep 4, 2025
How to fix excessive noise from Chicago Electric 91938 Saw?
- S
  sabrina77Sep 4, 2025
  Excessive noise or rattling in your Chicago Electric Saw could be due to internal damage or wear, such as with the carbon brushes or bearings. It is suggested to have a technician service the tool.
B
Brian BishopSep 7, 2025
Why Chicago Electric Saw operates slowly?
- S
  Steven RaymondSep 8, 2025
  If your Chicago Electric Saw is operating slowly, it may be due to an extension cord that is too long or has a wire size that is too small. Try eliminating the use of the extension cord. If an extension cord is necessary, use a shorter or heavier gauge cord.