What to do if my Chicago Electric 98199 will not start?
If your Chicago Electric Saw won't start, there are a couple of things to check: * First, make sure there is power at the outlet. * Second, verify that the cord is properly plugged in.
What to do if the blade binds, slowing or stopping my Chicago Electric 98199 Saw?
If the blade of your Chicago Electric Saw binds, slowing it down or stopping it, consider the following: * Ensure the material is correctly aligned on the saw and that both ends are supported. The material must be flat on the table, flush against the fence, and supported on both ends. * Check the condition of the material and verify that the blade is compatible with the material being cut. The material may be wet or contaminated, or an inappropriate blade may be in use.
How to prevent wood from burning at the ends when cut with a Chicago Electric 98199?
To prevent wood from burning at the ends when cut with your Chicago Electric Saw: * Clean the blade using blade cleaner or mineral spirits, as a dirty blade can cause burning. * Check the position of the work material on the table. The material must be flat, flush against the fence, and supported on the ends to prevent binding.
What to do if material frays or chips out when using my Chicago Electric 98199?
If the material frays or chips out when using your Chicago Electric Saw, consider these points: * Ensure the finished side of the material is facing up. The bottom and back side are prone to chip out. * Check the blade for damaged teeth and sharpen or replace the blade if necessary. A dull or chipped blade can cause fraying. * Verify that the blade is appropriate for the material being cut. For cross-cutting hardwood and precision cuts, use a thin kerf blade with 60 or more teeth. * Use a thin piece of scrap material, such as 1/4” plywood, underneath or behind the material to support the edges during cutting.
How to prevent wood burning when cutting with Chicago Electric Saw?
If wood burns at the ends when cut with your Chicago Electric Saw, it could be due to a dirty blade. Clean the blade using blade cleaner or mineral spirits. Another cause could be that the material is binding. Check the position of the work material on the table, ensuring it is flat, flush against the fence, and supported on the ends.
Why does my Chicago Electric Saw operate sporadically?
If your Chicago Electric Saw operates sporadically or at low power, it could be due to: * A low power supply or improper extension cords. Check your power supply and power cords. * Worn or cracked carbon brushes. Inspect the carbon brushes and replace them if they are damaged or worn.
What to do if material frays when using Chicago Electric 98199 Saw?
If the material frays or chips out when using your Chicago Electric Saw, consider these points: * Ensure the finished side of the material is facing up. * Inspect the blade for damage or dullness; sharpen or replace if needed. * Verify that the blade is appropriate for the material you're cutting. * Support the material, using a thin piece of scrap material underneath or behind it.
Why does the blade bind on my Chicago Electric Saw?
If the blade binds, slowing or stopping your Chicago Electric Saw, first, ensure the material is flat on the table, flush against the fence, and supported on both ends. Second, check the condition of the material and ensure the blade is compatible with it.
General| Motor Power | 15 Amp |
|---|---|
| Amperage | 15 Amp |
| Voltage | 120V |
| Arbor Size | 5/8 inch |
| Blade Diameter | 10 inches |
To Next Page
