Instruction 2111.80B 04/05 4
G. TOOLS REQUIRED
Use only the proper tools when dismantling or repairing any CHICAGO PUMP equipment. Tools required
for disassembly and assembly of dry pit pumps are as follows:
H. RECOMMENDED LUBRICANTS
GREASE OIL
CITGO Lithium CITGO Citgard 10W
EP-2 Petro Canada 10W
Mobil DTE Light
In cases where abnormal conditions exist, such as very high temperatures, it is advisable to consult a
lubrication engineer to determine. the proper lubricant to use. If this is not practical, contact your
CHICAGO PUMP representative stating your conditions, and alternative recommendations will be
provided.
I. RECOMMENDED CLEANING SOLVENT
Safety - Kleen, or any equal grade of non-flammable industrial cleaner.
J. SPARE PARTS RECOMMENDATIONS
The parts list accompanying the cross-section drawing included with this manual denotes items
recommended to be carried as spare parts. It is impossible for CHICAGO PUMP to accurately determine the
predicted life of any parts subject to wear because of the varying severities of duty exerted on each individual
unit manufactured. The list includes parts recommended to be carried for one to five years of operation. It is
recommended that the following parts not be reused at re-assembly, even if showing no apparent wear:
Grease seals
Shaft Sleeve (for Packed
Pump)
Snap Rings Thrust Bearing
Packing Mechanical Seals
Impeller Locknut Wear Rings (When Furnished)
Radial Bearing Filter Insert (When Furnished)
Gaskets
Bearing Locknut & Washer
Screwdriver Several Good Blocks of Wood or a Bench
Standard Wrenches Bearing Puller
Retaining Ring Pliers Wheel Puller / Bars
Lifting Sling Bearing Heater
Allen Wrenches Emery Cloth
Torch Wooden Mallet
To Next Page
Loading...