Chicco 06627 - Page 88

40
41
Parent unit
(receiver)/
child unit
(transmitter)
power and
link indicator
(8) off
The parent
unit (receiver)
does not
emit any
sounds
- No discernible sounds
are arriving to the child
unit (transmitter).
- .The voice activation
function has been se-
lected.
- Parent unit (receiver)
volume set at minimum.
- Child unit alkaline
batteries and/or parent
unit lithium-ion battery
completely flat.
- The parent unit (recei-
ver) may be off in Baby
Monitor mode.
- Just as soon as discernible sounds
from the environment are present, the
transmitter will be activated. In
any case, for peace of mind, test
transmission with the help of another
person who can try to speak in the
room the child unit (transmitter)
is on.
- If the display shows the
icon,
the voice activation function is active.
As soon as sounds present in the
child unit environment exceeds the
threshold for voice activation, the
parent unit will emit sounds.
- Adjust the parent unit (receiver)
volume, pressing
the + volume adjustment button (5a)
until sounds can be heard.
- Replace the alkaline batteries in the
child unit and/or charge the lithium-
ion battery in the parent unit.
- Switch on the parent unit (receiver)
in Baby Monitor mode.
The parent
unit (receiver)
display does
not show any
image (black
screen)
-The parent unit (recei-
ver) and/or child unit
may be off.
- Absence or loss of link
with the child unit.
- The voice activation
function has been se-
lected.
-Check that both units are on cor-
rectly.
- If the display shows the
, icon,
move the units closer together and/or
relocate the units themselves in order
to reduce the number of obstacles,
metal structures, reinforced concrete
walls, etc. interposed between them
and/or check that the child unit is on.
- If the display shows the
icon,
the voice activation function is active.
As soon as sounds present in the
child unit environment exceeds the
threshold for voice activation, the
parent unit will emit sounds and will
display an image of the child again in
real time.