10 11
3D
3D. Line up the tabs on the Hubcaps
(G) with the holes on the Wheel.
Snap the Hubcap onto the Wheel to
cover the Washer and Pin. Repeat
Step 3D for other side.
Pull on each Wheel to make sure the
Wheel assembly is securely attached
to the frame.
3C. Secure the Wheel to the Rear Axle
using a Pin (F). Push the straight side
of the Pin through the hole on the
Rear Axle. The curve on the Pin must
curve around the outside of the Rear
Axle, as shown. Make sure Washer is
between the Pin and Wheel. Repeat
Steps 3A-3C for other side.
3C
WARNING
Check that the wheels are fitted correctly.
How to Assemble Stroller
How to Assemble Stroller
To Next Page
Loading...
