66
67
STAGE 1 & 2
REAR-FACING INSTALLATION
STAGE 1 & 2
REAR-FACING INSTALLATION
“CLICK”
“CLICK”
PULL
st
nd
PULL
Locate the LATCH anchor bars in your vehicle. Attach both LATCH
Connectors to the vehicle LATCH bars.
Pull up on the end of the LATCH Adjuster strap (Pull 1
st
) until
strap is tight.
Pull on the SuperCinch® LATCH Tightener strap (Pull 2
nd
) to secure the
Child Restraint.
5
4
6
4
CHECK YOUR WORK
Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Child Restraint should not move more than 1” (25 mm) from
vehicle seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING use. Make sure infant’s head
does not fall forward. If necessary, loosen the Latch Strap, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
PULL
1
5
PULL
2
6
Do not install by this
method for a child weighing
more than
35 lbs (15.9 kg)
.
INSTALL USING LATCHINSTALL USING LATCH
To Next Page
