84
85
STAGE 3
FORWARD-FACING INSTALLATION
STAGE 3
FORWARD-FACING INSTALLATION
CHECK YOUR WORK
Hold Child Restraint at each side near FORWARDFACING vehicle belt path. Pull
side to side and forward. Child Restraint should not move more than 1” (25 mm)
from vehicle seat back or side-to-side.
Make sure Bubble is between lines on label for FORWARD-FACING use. If
necessary, loosen the LATCH and Tether Straps, re-adjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
INSTALL USING LATCH
INSTALL USING LATCH
Locate Tether anchor in your vehicle. Attach Tether Hook.
Pull Tether Adjuster strap to tighten.
7
7
To Next Page
