Chicco Lullaby Primo - Packing Up the Playard; Initial Disassembly Steps

42 43
Cleaning and Maintenance
This product requires regular maintenance. The cleaning and maintenance of the
playard must only be carried out by an adult.
The mattress cover and changer insert can be washed, remove the boards from the
mattress cover as shown.
Do not immerse the wooden boards in water. Wipe clean with a damp cloth and mild
detergent (do not use bleach).
CLEANING
Please refer to the care label for instructions on cleaning the fabric parts of the playard.
Periodically wipe clean plastic parts with a soft damp cloth. Always dry the metal
parts to prevent the formation of rust if the playard has come into contact with water.
MAINTENANCE
Periodically check the playard for loose screws, worn parts, torn material or stitching.
Replace or repair the parts as needed. Use only Chicco replacement parts. Keep the
playard in a dry place. If playard becomes wet open playard and allow to dry
completely. Prolonged exposure to direct sunlight may cause the fabric to fade
and plastic parts to warp.
Locate the zipper on the
mattress cover and unzip.
Remove all of the floor
boards and set them aside.
Undo the zippers and
remove the Changer
Insert.
Trouble Shooting Guide
TOP RAILS FAIL TO LOCK INTO AN UPRIGHT POSITION :
Before top rails can be locked, the center floor hub must be pulled up as high as the 4
corners. If needed, pull up on the center floor hub release strap. If necessary, pull the
release strap up with one hand and lock rails one at a time. If you are still unable to
lock the top rails, call Chicco Customer Service (pg. 47).
THE FLOOR JOINTS DO NOT FLATTEN:
Turn playard upside down and make sure joints are free from foreign objects.
TOP RAILS DO NOT UNLOCK TO FOLD:
Lift top rail first, then squeeze to release. Before top rails can be unlocked, the center
floor hub must be pulled up. If needed pull up on the center floor hub release strap
as high as the 4 corners.
FLOOR JOINTS DO NOT UNLOCK:
Pull up on the center floor hub release strap to unlock floor joints.
FOLDED PLAYARD DOES NOT FIT INTO MATTRESS PAD:
Pull up on the center floor hub release strap and gather playard legs towards the
center to make the playard more compact. If necessary, shift playard lower on pad
or turn slightly and try again.
BASSINET DOES NOT FIT ONTO PLAYARD:
Playard top rails must be fully upright and locked. Playard floor must be flat.
LULLABY PRIMO MOBILE DOES NOT FIT INTO CORNER SLOT:
Make sure fabric is not covering the slot in the bassinet corner. The mobile will fit
onto any of the corners - Try another corner.