To Next PageTo Next Page
Need help?Do you have a question about the Chicco Lullaby and is the answer not in the manual?
General| Mattress Included | Yes |
|---|---|
| Bassinet Included | Yes |
| Changing Table Included | Yes |
| Mobile Included | Yes |
| Wheels | Yes |
| Foldable | Yes |
| Material | Metal |
| Features | Removable bassinet |
| Battery | No |
| Storage | Side storage pocket |
Read instructions carefully, ensure constant supervision, and never leave child unattended.
Ensure proper assembly, check limits, and prevent suffocation/fall hazards.
Avoid strings, plastic bags, and items that could cause strangulation or climbing.
Keep away from heat, windows with cords, and never move the product with a child inside.
Remove plastic bags, ensure all rails and hub are locked, and keep fingers clear during assembly.
Remove playard from bag, unfasten straps, and stand the folded unit upright.
Pull the center floor hub up to the level of the top rails to lock it in place.
Lift each top rail until it locks securely. Ensure all four rails are locked before proceeding.
Push down on the center floor hub until the feet touch the floor and the playard bottom is flat.
Place the mattress pad with the padded side up and fold straps securely under the floor.
Thread the mattress pad straps through the designated holes on the playard floor.
Pull straps through the frame, secure tightly with D-rings and hook/loop fasteners.
Remove mattress pad. Lay bassinet over playard and push all twelve clips securely onto top rails.
Slide metal bars into sleeves and connect them together to form the bassinet structure.
Fasten end snaps and pull toggles through loops on the sides to secure the bassinet.
Place the mattress in the bassinet, ensuring all straps are folded neatly underneath.
Keep child within reach and never leave them unattended on the changing table.
Discontinue use at 25 lbs. Do not use on unsupported surfaces or as a play area.
Always remove the changing table when child is in playard. Do not use if damaged.
Pull back the fabric sleeve on the changing table to expose the internal metal tube.
Attach metal end pieces to poles, ensuring the spring button passes completely through the holes.
