15
30° C
cles on “i-Size compatible” seats as indicated by the vehicle manufac-
turer in the vehicle users’ manual.
If in doubt, consult either the child restraint manufacturer or the vehi-
cle manufacturer. If the vehicle does not have an i-Size seat check the
vehicle compatibility list, available via the QR code on the product
installation label and at the end of this manual.
INSTALLING THE CAR SEAT AND POSITIONING THE CHILD IN
THE VEHICLE
WARNING:
- The car seat must only be installed using a 3-point vehicle seat belt
(Fig. 1).
- Never t the car seat with a 2-point safety belt (Fig. 2)!
- Never t the car seat in a manner dierent from the one indi-
cated! (Fig. 3)
Installation with the vehicle’s 3-point seat belt (see illustrations from 1 to 5)
How to clean the fabric cover
The child car seat’s fabric cover can be removed and washed by hand
or in a washing machine at 30°C. Please refer to the cleaning instructions
on the fabric label which illustrates the following washing symbols:
Machine washable at 30°C.
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents. Do not dry the fabric cover
within a dryer, let it dry without squeezing it.
The fabric cover must only be replaced with another cover approved
by the manufacturer, since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car seat, never use it
without its fabric cover.
To remove the fabric proceed by pulling the cover o the frame
How to clean the plastic and metal parts
Clean the plastic and coated metal parts with a damp cloth only. Nev-
er use abrasive detergents or solvents.
The moving parts of the child car seat must not be lubricated.
Checking the condition of the components
It is recommended to regularly check the condition of the following
components to make sure they are not damaged or worn:
• Fabric cover: check that the padding does not come out from the
seams. Check the condition of the seams: they must always be in-
tact and undamaged.
• Harness straps: make sure there are no signs of abnormal wear in
the fabric weave, with clear thinning at the height of the adjust-
ment strap.
• Plastic parts: check that the plastic parts are not worn out, damaged
or faded.
To Next Page
Loading...
