PARTS LIST:
A. Infant Insert
B. Headrest
C. Canopy Front
D. Shoulder Pads
E. Crotch Strap Pad
F. Boot Bottom
A
B C
D E F
WARNING: Avoid serious injury or death to your child. Never use
your KeyFit car seat without seat padding in place. You must read and
understand the KeyFit Zip Softgoods Removal instructions AND the
instructions in the User Guide. Keep these instructions. Fold instructions
and store with the booklet in the KeyFit Base. If you do not understand
these instructions, DO NOT attempt to remove the Softgoods, STOP and
call Chicco at 1-877-424-4226.
INSTRUCTIONS: KeyFit Zip Softgoods Removal
IMPORTANT: Please also refer to the instructions that came with your product.
TO REMOVE THE SEAT PAD:
Unzip the back Canopy zipper (as shown) and refer to User Guide to remove the Canopy. Remove the Boot
(See Steps 6a-6c). Remove Shoulder Pads (See Step 7). Remove the Crotch Strap Pad (See Step 8).
Remove the Headrest and Newborn Insert.
See Steps 1-5 to finish removing the Seat Pad.
SHOULDER PADS: To remove the Shoulder
Pads undo the Velcro as shown.
7
IMPORTANT! If the Crotch Strap Pad prevents the
harness from properly fitting a small Infant, remove
immediately and store for future use.
CROTCH STRAP PAD: Unbuckle the Harness and
remove Crotch Strap Pad by locating the Tab and
pushing it through the Harness Buckle. Pull the Tab out
through the front of the Harness Buckle and remove.
8
4 1
Fabrics may be spot-cleaned with mild soap and water, or machine washed in cold water on delicate cycle using
mild detergent. Hang to dry. DO NOT BLEACH.
Please consult your product manual for instructions on additional care and maintenance instructions.
CLEANING INSTRUCTIONS:
IS0117.E
To Next Page
Need help?
General
