Do you have a question about the Chicco MyFit Zip and is the answer not in the manual?
Height Capacity | Up to 57 inches |
---|---|
Recline Positions | 4 |
Harness Type | 5-point |
Fabric | Machine washable |
Cup Holders | 2 |
Forward-facing Weight Capacity | 25-65 lbs |
Forward-facing Height Capacity | Up to 54 inches |
Booster Weight Capacity | 40-100 lbs |
Booster Height Capacity | Up to 57 inches |
Car Seat Weight | 25 lbs |
Removable Seat Pad | Yes |
Side Impact Protection | Yes |
Convertible | Yes |
Type | Convertible |
Installation | LATCH or seat belt |
Completely loosen harness by pressing release button and unbuckling chest clip and harness buckle.
Undo the hook and loop fastener on both waist belt pads and remove.
Unhook the hook and loop tab and remove both shoulder pads.
Push fabric tab through back slot of harness buckle to remove crotch strap pad.
Unzip the seat back pad at the headrest and unhook tabs near shoulder belt guides.
Unzip seat bottom pad, thread crotch strap through fabric, and remove.
Press orange button on cup holder bottom edge to remove.
Lift seat bottom pad and undo elastic straps attached to latch storage compartment.
Thread crotch strap down through fabric and pull fabric around seat.
Locate and unhook elastic straps on the back of the headrest.
Pull plastic tabs at headrest top and lift up on headrest fabric.
Remove the headrest fabric pad.
Unhook the armrest fabric loop from the side hook near the vehicle belt path.
Undo the snap attaching armrest fabric to the backrest seat pad.
Unhook both elastic straps on the back of the child restraint.
Unhook elastic strap from side hook and top hook near vehicle belt path.
Remove the backrest seat pad from the child restraint.
Turn restraint over, locate metal bar, turn it, and pull crotch belt out.
Push metal bar through slot on top of seat and pull through, laying flat.
Place the backrest seat pad onto the child restraint.
Hook the elastic strap onto the side hook and top hook near vehicle belt path.
Tuck fabric into the groove around the child restraint and hook elastic straps.
Slide armrest fabric onto armrest and snap to backrest seat pad.
Hook the armrest fabric loop onto the side hook near the vehicle belt path.
Place the headrest fabric pad onto the headrest.
Tuck headrest fabric into groove at top, pushing tabs until they snap.
With headrest high, hook elastic strap onto the back of the headrest.
Place seat bottom fabric, pull crotch strap up through fabric.
Lift latch storage door, wrap elastic straps on seat bottom pad around ends.
Match R and L cup holders, insert ensuring lip fits groove and clicks.
Re-attach seat bottom pad, thread crotch strap, and zip pad at back and front.
Re-attach seat back pad by zipping top and attaching hook/loop tabs.
Replace crotch strap pad by sliding buckle up and securing tab on back.
Re-attach shoulder pad by folding hook and loop tab over harness strap.
Attach waist belt pads by wrapping around harness waist strap and fastening.