1. Safety instructions
2
1-1 Electrical safety requirements
1) Wiring work must be done by formally qualified electricians.
2) All wiring work must meet the electrical safety specifications.
3) The air conditioner must be well grounded, namely, the air conditioner must have its main switch
reliably grounded.
4) The air conditioner must be provided with separate power supply according with the rated
parameter value.
Please contact our authorized service center for installation. Improper installation may result
in water leakage, electric shocks, fires and other accidents.
Never put sticks or other objects into the air inlet and outlet.
Do use within the required voltage and frequency with protection devices equipped
accordingly. Never use any copper wire to replace the fuse to avoid failures or fires.
The air conditioner shall have its ground wire firmly connected with that of the power source.
While cleaning, never splash water onto the air conditioner, in order to avoid failures or
electric shocks.
Never have the indoor or outdoor unit inlet or outlet blocked to avoid impact on the
performance of the air conditioner and prevent failures.
If idle for long, disconnect the power supply to ensure safety and save energy.
When restarted after a long-term shutdown, do carefully check whether the air conditioner
and its power lines are normal. If the power lines are damaged or need replacing due to other
reasons, please contact our after-sales service staff or authorized repair professionals to
avoid electric shocks, overheating, fires or other accidents.
Never place any water container on the air conditioner to avoid electric shocks due to water
immersion.
After a long-term use, please confirm whether the mounting platform is worn, and if worn, the
air conditioner may fall to cause casualties.
Never operate the switch if your hand is wet to avoid electric shocks.
In time of repair, stop the air conditioner with the power supply cut off, or the high-speed
rotation of the internal wind turbines may lead to injuries.
Never use any other fuse beyond the capacity regulated in this Manual. Never use any iron
or copper wire to avoid failures, fires and other consequences. Do use the special circuit
under the rated voltage for air conditioners.
To Next Page
Loading...
