3. Use instructions
6
3-1 Use of remote controller
The frequency conversion wall-mounted type (standard), roof-mounted type (standard), base-mounted
type (standard), coil-based type (optional) and duct-based type (optional) have the remote controller use
(Specifications: smart universal type) introduced as follows:
The smart universal remote controllers (compatible to line controllers or lamp panels respectively)
The following remote controller “Swing” button, “High wind” button, “Lamp” button and “Purifier” button
apply to special new models but not to ordinary ones.
Never put the remote controller close to such heat sources as electric blankets or heating
furnaces.
Never put the remote controller at the place subject to direct sunlight.
Be careful not to have it fall, or it may be damaged.
Never have any obstacle between the signal receiver and the remote controller of the air
conditioner to avoid impact on signal transmission and receiving.
Never have water and other liquids splashed on the remote controller.
To Next Page
Loading...
