12
2. Open the plastic slot cover on the armrest by pushing it
upwards and then opening it downwards.
3. Repeat previous steps for the opposite armrest.
Assembly / Operating Instructions
Attaching infant carrier to stroller
This stroller is designed for use with Britax (Orion/Strider/Cruiser)
infant carrier.
1. Remove armrest’s fabric cover by:
• Holding the fabric cover rmly and pull it away from the
armrest to release the rst plastic peg (located underneath
the fabric cover).
• Then slide the fabric cover towards the backrest of the
stroller and pull out to release the second and third plastic
pegs. This will allow the fabric cover to be detach from the
armrest completely.
To remove
rst plastic peg
To remove
second plastic peg
To remove
third plastic peg
To Next Page
