Chili Technology ChiliPAD cube Single Zone - Connecting the Power; Filling the Cube with Water; Turning the Cube On

pg.12


SET‐UPCONTINUED
ConnectingthePower.
Plugthepowercordintoanoutlet.
Note:Thisdevicehasagroundedplug.Toreducetheriskofelectricshock,thisplugis
intendedtofitinagroundedoutletonlyoneway.Ifitdoesnotfit,contactaqualified
electrician.Donotmodifythepluginanyway.

FillingtheCubewithWater. Distilledwaterisrecommended
 Youwillneedtofillthewaterreservoirbeforethefirstuse.
 ThewaterreservoirislocatedonthetopcenteroftheCube.
 Unscrewandremovethecap,thenaddwateruntilthereservoirisfull(approximately
14oz/390ml).Note:HaveadditionalwaterreadytopourafterCubeisstartedtofillthe
tubinginthePad.
 TurntheCubeonbytouchingtheON/OFFbutton.
 TheCubewillbeepandthepumpwillbegintorun(Thisiswher eadditionalwaterwill
beneededasthewaterinthereservoirwillbepumpedintothePad).

AswaterstartscirculatingthroughthetubinginyourChiliproduct.Continueto
slowlyfillthereservoiruntilthewaterlevelreachesthebottomofthecapthreadlines
(thisamountwillvarydependingonthesizeofyourpad).
o Usecleanwater.Distilledwaterisrecommended.
o DonotimmersetheCubeinwatertofill.
o BecarefulnottospillwaterontheCube.
o RefillthewaterreservoirwhenthewaterlevelgetslowortheLowWaterlight
comeson.TheCubewillnotoperatewhenthewaterlevelinthereservoiris
tooloworempty.

TurningtheCubeOn.
PresstheON/OFFbuttonontheCubeorremote.TheCubewillbeepandthepumpwillbegin
torun.

