Chili Technology ChiliPad - ChiliPad Tips and Care; Usage Tips and Tricks; Water Maintenance

14 15
Tips & Tricks
Your Chilipad Cheat Sheet
To pair your remote with your cube, turn o the cube rst. If you have a Dual Zone
system (two cubes), make sure the other one is o. Hold down the power
button with cube o until you hear a long beep and the display ashes “888”. Turn
the remote on, you should hear a beep to conrm connection. (Note: The cube
can be controlled with the remote or the buttons on it’s display.)
To switch between °F and °C, turn o the remote,then turn the cube on with the
display panel. Press and hold the remote’s On/O button for 2 seconds.
The “LO” setting is 55°F, and set to “HI” the maximum temperature is 110°F. In
many cases these temperatures are not fully achieved due to ambient air
temperature, humidity in the room, and objects or walls near the cube.
Inspect the tube regularly for kinks and sharp angles that would limit water ow,
decreasing the systems’s ability to heat or cool.
Condensation is a natural result of warm and cold temperatures meeting, this
applies to the tube and mattress as well. Adjust your room temperature or Cube
to narrow the dierence of temperature, and reduce condensation.
ChiliPad care
Maintaining Your Sleep System
WATER MAINTENANCE
We recommend using distilled water for optimimum performance.
One time per month, add one packet of ChiliPad cleaning solution. You can purchase
additional packets of the solution at chilitechnology.com
CLEAN THE CUBE AS NEEDED
With the cube turned o and unplugged, use a clean damp cloth to clean the outside
of the cube and remote control. Be careful not to get water inside of the cube.
Use a can of compressed air to blow through the intake/exhaust vents on all sides
removing dust and debris. Never submerge or get water inside the cube.
WASH THE PAD AS NEEDED
The pad is machine washable. Wash the pad preferably in a front-load washing ma-
chine with cold water on a gentle/delicate cycle. Secure the tail pipe (part that runs
from the pad to the cube) with a thick rubber band to minimize risk of it ailing in the
spin cycle and damaging the connector.
Dry on DELICATE/AIR ONLY cycle – Use NO HEAT setting or air dry.