6
ROUTING OF THE SEAT BELT
For group I (9-18kg) use
fig. 7
Put the child restraint in a rear-facing position and use the base support on the seat of car
(fig. 8). Pull the seat belt and pass it through the hooks located on the back rest and the base
of the car seat, as shown in fig. 8. Buckle the seat belt and fix it with the red clip.
NOTE: Extreme danger! Do not use rear facing child restraint in passenger seats equipped
with airbag. Do not use in forward facing position when child’s weight is under 9kg.
WARNING: Do not place your child in a sleeping bag, blanket or other bulky wrapping before
putting child in restraint. The shoulder straps will not fit snugly and child won’t be safe.
NOTE: Be sure to check whether the seat belts are snug and flat, not broken and tightened
properly. You must check this each time when child is placed in the restraint system. After each
adjusting of the seat angle, please pull the vehicle seatbelts tight again and close them tightly
using the red clip.
Place the car seat in forward facing position on the seat of the car (fig. 7). Adjust the
backrest in the described way. To achieve better fixing push the car seat maximum to the
vehicle seat backrest. Pull the seat belt to the part between the backrest and the base of the
car seat, as shown in fig. 7. One of the seat belts straps must pass horizontal through the
seat’s base. Buckle the seat belt and pull it. Fix with the red clip.
For group 0+ (less than 13 kg) use
fig. 8
To Next Page
Loading...
