4
CLEANING THE FOUNTAIN
Note: Do not allow dipping candy to harden in the fountain bowl
or on the fountain tiers, as cleaning will become very dicult.
01. Be sure fountain is turned o and unplugged from electrical outlet.
02. Carefully remove tower and auger from base. Separate the three tier pieces of the tower.
Wash with mild soap and water. To clean the inside of tower, push a damp paper towel or
thin dishcloth through the channel.
03. Pour excess dipping candy from the fountain bowl into a microwave-safe bowl for use later following
instructions on dipping candy package, or into a trash receptacle. DO NOT pour excess dipping candy
down the drain as dipping candy will harden and may cause plumbing problems.
04. Wash the inside of the fountain bowl with mild soap and water, being careful not to
immerse fountain base in water, as the base houses the electrical unit and may become
damaged if immersed in water.
05. Wipe down the outside of the base with a damp cloth.
06. Allow fountain base, tower and auger to air dry completely before next use.
07. Wipe unit with a soft, dry cloth once dry, to remove any water marks.
Note: Do not place fountain base or pieces in dishwasher.
Do not use abrasive cleaners on fountain base or pieces.
TROUBLESHOOTING GUIDE
Push the FOUNTAIN button to turn the fountain o before
beginning any of the following troubleshooting techniques!
Troubleshooting
• Be sure fountain is situated on a stable surface
and leveled according to instructions on page 3.
• Make sure dipping candy is completely melted and not burnt
(burnt dipping candy may become lumpy).
• Be sure dipping candy is free of solid pieces of snacks.
• Be sure the correct amount of dipping candy is being used.
• Be sure HEAT button is on as dipping candy
will thicken upon standing.
• Be sure the correct amount of dipping candy is being used.
• The white lm is caused by a separation of the fat component
in the ingredients. Stir vigorously to diminish.
• Be sure HEAT button is on as dipping candy will thicken
and fat will separate from the cocoa upon standing.
Problem
Inconsistent ow of melted dipping
candy over the tiers.
Fountain motor stops as soon as the
fountain is started.
Fountain stops owing after it had
been owing smoothly.
Fountain ow slows down.
Melted dipping candy hardening
in bowl and/or on tiers.
A white lm appears on melted
dipping candy in the fountain bowl.
To Next Page
Loading...