4 SETUP AND MAINTENANCE
Cholestech LDX System Procedure Manual
I
R
O
For Information Only
Recommended Optional Information
< TABLE OF CONTENTS
1.7 Cholestech LDX System Initial Setup
The Initial Setup Checklist is provided to assure that all of the environmental conditions
are met and that the Cholestech LDX System runs properly during the initial setup in
the laboratory.
The Instrument History Record can be used to record any service performed on the
Cholestech LDX System or other instruments in your laboratory. Both forms can be found in
the
Master Forms
section of this manual.
Cholestech Corporation will provide technical support to each Cholestech LDX System user.
Any questions regarding the operation of the Cholestech LDX System may be directed to:
Cholestech Corporation
Technical Service Department
3347 Investment Boulevard
Hayward, CA 94545 U.S.A.
Tel 800 733.0404
Fax 510 732.7227
www.cholestech.com
techservice@cholestech.com
1.8 Maintenance and Cleaning of the Cholestech LDX System
No maintenance is required other than routine cleaning when necessary.
• Clean the outside of the Cholestech LDX Analyzer case with a clean, damp, non-
abrasive cloth. Most spills and stains will be removed with water or a mild detergent.
A solution of 70% isopropyl alcohol, or 5% bleach, or any nonstaining, commercially
available disinfectant are all appropriate cleaning agents. Do not immerse the
instrument in water or other cleaning fluid. Do not use any abrasive cleanser.
• When necessary, clean the cassette drawer with a cotton swab moistened with water, a
70% isopropyl alcohol solution, 5% bleach or disinfectant. Dry with a second cotton swab.
You can record maintenance and cleaning performed on the Cholestech LDX System and
other instruments in your laboratory on the Equipment Maintenance/Cleaning Log in the
Master Forms
section of this manual.
R
R
To Next Page
Loading...