Chord Electronics Mojo 2 - Page 18

Chord Electronics
Mojo 2 | User manual
18
7.6 Lockdown mode
Mojo 2 benefits from a button-lock option where all controls can be disabled for travel use. To activate button
lock, press the menu button six times until magenta is displayed, then simultaneously press both the volume up
‘+’ and volume down buttons ‘-‘ once, until all three Mojo 2 buttons display magenta; the controls are now
disabled. After two seconds, the volume buttons will revert to displaying the set output volume once again,
however, the menu button will continue to display magenta to indicate button-lock mode is active.
With button-lock mode activated, a single press of the (magenta) menu button will immediately return to the
button-lock menu. From here, simultaneously press both volume up ‘+’ and volume down buttons ‘-’ once to
unlock the buttons (indicated by the volume buttons returning to unlit) and press menu again to exit button-
lock mode and proceed through the menu.
NOTE
When in button-lock mode, the power button is temporarily disabled, however, the auto power-
shutdown feature is still functional.
7.7 Restore factory settings
Mojo 2 features a factory reset mode that restores the device to the original factory settings: DSP flat and
Crossfeed o. To reset the device, press both the ‘+’ and ‘-‘ simultaneously from either the DSP menu mode, or
the Crossfeed menu mode.