Chord Electronics Mojo 2 - Volume adjustment

Chord Electronics
Mojo 2 | User manual
9
TIP
Mojo 2 will auto-shutdown after 10 minutes without an input signal.
6.7 Brightness adjustment
Mojo 2 oers two levels of button brightness: normal and low. Normal is activated as standard, however, to
alternate between low and normal brightness modes, press menu once (menu button will show blue) then
‘-’ repeatedly to move between normal and low modes; any lit buttons will increase or decrease in
brightness accordingly. Once chosen, the selection will be remembered and Mojo 2 will automatically exit
the menu settings in 10 seconds. Alternatively, press and hold menu to exit the menu immediately.
6.8 Volume adjustment
Mojo 2 benefits from two main volume ‘ranges’: low and high, as indicated by the colour of the menu
button: unlit (low); white (high). As the volume is changed, Mojo 2 moves automatically into the respective
volume ranges; the menu button colour changes accordingly.
With chosen devices and headphones now connected (but not on/in ear), and Mojo 2 powered on, the
volume can be reduced to zero using the volume down ‘-‘ controls until both volume buttons and menu
button are unlit. From unlit, the volume can be slowly increased by pressing the volume up ‘+’ button. Both
buttons slowly change colour with changing volume level.
Always set the volume level to zero before commencing initial playback and take precautions
when using Mojo 2 in high volume mode to protect from hearing damage.