integrated amplifiers technical information
CPM 2600 CPM 3300
output power 120w rms per channel 220w rms per channel
0.05% distortion into 8 0.05% distortion into 8
harmonic distortion 10Hz -91dB 10Hz -91dB
1kHz -93dB 1kHz -93dB
10kHz -90dB 10kHz -90dB
20kHz -87dB 20kHz -87dB
intermodulation distortion
all inputs -100dB -100dB
signal to noise ratio -93dB -93dB
channel separation 10Hz 90dB 10Hz 90dB
1kHz 90dB 1kHz 90dB
10kHz 90dB 10kHz 90dB
20kHz 85dB 20kHz 85dB
channel balance 0.01dB 0.01dB
potentiometer performance 0dB -20dB -60dB as CPM 2600
17 secs ±3 secs for full travel of 300º
balanced inputs Disc 1 and Disc 2 as CPM 2600
XLR and RCA wired
asymmetrically in parallel
unbalanced inputs
Disc 1 yes yes
Disc 2 yes yes
Video yes yes
Radio yes yes
Tape 1 yes yes
Tape 2 yes yes
outputs
1 1 pair WBT speaker binding posts as CPM 2600
2 RCA unbalanced pre-amp out
2 for tape RCA unbalanced
frequency range 2.5Hz-80kHz (-3dB) 2.5Hz-80kHz (-3dB)
input max
Disc 1 8V rms (balanced) 8V rms (balanced)
7V rms (unbalanced) 7V rms (unbalanced)
Disc 2 8V rms (balanced) 8V rms (balanced)
7V rms (unbalanced) 7V rms (unbalanced)
Video 8V rms 8V rms
Radio 3V rms 3V rms
Tape 1 3V rms 3V rms
Tape 2 3V rms 3V rms
input impedance
balanced 94k 94k
unbalanced 47k 47k
output max 15.6V rms balanced 15V rms balanced
7.8V rms unbalanced 7.5V rms unbalanced
pre-amp output impedance 470 100
output impedance 0.03 0.03
slew rate 70V per µs. 1kHz 20V square wave 70V per µs. 1kHz 20V square wave
dimensions
mm/w/h/d 420 x 133 x 355 420 x 155 x 355
weight 16kg standard rod finish 19kg standard rod finish
note with 4 leg integra finish the width is 480mm and 3mm is added in height. Each leg weighs 1 kg.
21
To Next Page
Loading...
