EasyManuals Logo

Chord Hugo TT 2 Quick Start Manual

Chord Hugo TT 2
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Connecting the power to Hugo TT 2 5.0
Connecting to a Hugo M Scaler from the Hugo TT 2 3.0
Connect only the supplied power supply to the DC 15V input of Hugo
TT 2. Once connected to the Hugo TT 2, it may start automatically.
Please make sure none of your other devices are switched on at this
point.
If using Hugo M Scaler you should use the Dual BNC cables provided
to connect it with the Hugo TT 2. By using M Scaler all of your inputs
must now be connected to M Scaler and not TT 2 - refer to the M Scaler
User Manual.
OPT OUT
OPT OUT
S/PDIF
S/PDIF
DUAL BNC OUT
DUAL BNC OUT
Chord Electronics
Hugo TT 2 | Quickstart Manual
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
info@chordelectronics.co.uk
chordelectronics.co.uk
Quickstart Manual
Introduction 1.0
Welcome to the Hugo TT 2 Quickstart Guide. This shortened guide is
supplementary to the main manual which should be referred to for full
safety and operational information.
Please note, more information on any of these topics is listed within the
full manual found under the product page:
chordelectronics.co.uk/product/hugott2
Warranty 1.1
The Hugo TT 2 comes with a comprehensive 3-year warranty. To
activate this warranty, please register your device via the Chord
Electronics website:
chordelectronics.co.uk/register-product
Note: please do not use a third-party charger with the Hugo TT 2 as it
voids any warranty
Connecting your source to Hugo TT 2 2.0
In order to use the Hugo TT 2, you must connect your source to any
input of the device. You can connect multiple sources if you wish and
select between them later from within the menu.
Please note that if you are using the USB input with a MAC/Linux
device you will not need a driver but if you are connecting a Windows
device it will need a driver from the Hugo TT 2 section of our website:
chordelectronics.co.uk/product/hugott2
Input
To connect an amplifier, such as TToby, to the Hugo TT 2, you should
connect the outputs of TT 2 to the inputs of your amplifier.
Connecting an amplifier to Hugo TT 2 4.0
Output

Other manuals for Chord Hugo TT 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chord Hugo TT 2 and is the answer not in the manual?

Chord Hugo TT 2 Specifications

General IconGeneral
Tap Length98, 304 taps
TypeDAC / Headphone Amplifier
DAC ArchitectureFPGA-based
InputsUSB, Optical, Coaxial, BNC, Bluetooth
OutputsRCA, XLR, 6.35mm headphone jack
Sample Rates44.1kHz to 768kHz
DSD SupportDSD512
PCM Support44.1kHz – 768kHz
Output Impedance0.042 ohms
Dynamic Range127dB
Dimensions235mm x 223mm x 46mm
Output Power (Headphone)7.3W RMS per channel at 8Ω

Related product manuals