Need help?Do you have a question about the Chord Hugo TT 2 and is the answer not in the manual?
General| Tap Length | 98, 304 taps |
|---|---|
| Type | DAC / Headphone Amplifier |
| DAC Architecture | FPGA-based |
| Inputs | USB, Optical, Coaxial, BNC, Bluetooth |
| Outputs | RCA, XLR, 6.35mm headphone jack |
| Sample Rates | 44.1kHz to 768kHz |
| DSD Support | DSD512 |
| PCM Support | 44.1kHz – 768kHz |
| Output Impedance | 0.042 ohms |
| Dynamic Range | 127dB |
| Dimensions | 235mm x 223mm x 46mm |
| Output Power (Headphone) | 7.3W RMS per channel at 8Ω |
Introduces the Hugo TT 2 as a powerful DAC/preamp/headphone amp and stresses reading the manual.
Advises against liquid contact and warns about operating near heat sources to protect internal components.
Details proper connection procedures, power-on sequence, and initial volume settings for safe operation.
Explains connecting the device to other equipment and the step-by-step power-on sequence for initialization.
Explains how the device automatically enters Headphone Mode when headphones are connected.
Describes how Amplification Mode enables the digital preamplifier for outputting to speakers or amplifiers.
Details DAC Mode for use with external amplifiers, providing a fixed 2.5V RMS line-level signal.
To Next Page
