Christie One Mount User Manual

Installing a Christie One Mount Instruction Sheet 1
020-101410-05 Rev. 1 (09-2016)
Copyright © 2016 Christie Digital Systems USA Inc. All rights reserved.
Installing a Christie One
Mount/Christie One Mount
Plus
This document provides instructions for installing the Christie One Mount or Christie One Mount Plus
and optional accessories to mount Christie projectors to a ceiling or truss.
Safety precautions
Tools required
• 5mm hex key
• 3mm hex key
Parts Lists
Christie One Mount (P/N: 108-506102-XX)
Christie One Mount Plus (P/N: 140-117100-XX)
Christie One Mount Extender Rod (P/N: 121-125109-XX)
Christie One Mount Rigging Kit (P/N: 121-126100-XX)
Prerequisites
• Christie One Mount maximum projector weight limit is 25 kb (55 lbs).
• Christie One Mount Plus maximum projector weight limit is 45 kg (99 lbs).
Failure to comply with these safety precautions may result in serious injury, or even death.
• Only Christie qualified technicians are permitted to open product enclosures.
• SHOCK HAZARD! Disconnect the from AC before moving, servicing, cleaning, removing
components, or opening any enclosure.
• A minimum of two people or appropriately rated lift equipment is required to safely lift,
install, or move the product.
• FIRE HAZARD! Do not install near any devices that produce heat such as amplifiers,
radiators, heat registers, or stoves.
• Do not exceed the maximum load capacity of the product.
• Do not install on a structure susceptible to vibration, movement, or change of impact.

Christie One Mount Specifications

General

Brand	Christie
Model	One Mount
Category	Projector Accessories
Language	English

Summary

Safety Precautions

General Safety Guidelines

Essential safety warnings and guidelines to prevent injury or death during installation.

Tools Required

Hex Keys

List of specific hex keys needed for the installation process.

Parts Lists

Component Identification

Identification of Christie One Mount and related accessory part numbers.

Prerequisites

Weight Limits and Requirements

Key requirements, including weight limits for projector mounting.

Installing the Christie One Mount

Ceiling Plate and Calibration Device Setup

Mount ceiling plate, insert calibration device, and attach projector adaptor plate.

Projector Plate Securing and Leveling

Secure projector plate, use leveling screws and standoffs for alignment.

Quick-Release and Setscrew Tightening

Secure projector with quick-release, ensure seating, and tighten setscrew.

Mount Calibration and Vibration Control

Calibrate mount position, use hex key if needed, and tighten screws for stability.

Installing the Christie One Mount Extender Rod

Extender Rod Installation Steps

Install extender rod between ceiling plate and calibration device, secure with setscrews.

Installing the Christie One Mount Rigging Kit

Rigging Kit Mounting

Install rigging kit to calibration device or extender rod and secure with setscrews.

Product Details

Dimensional Specifications

Diagrams and dimensions for mount and extender rod components.

Technical Support

Contact Information

Contact details for technical assistance across different regions.