Installing a Christie One Mount Instruction Sheet 1
020-101410-03 Rev. 1 (10-2015)
Installing a Christie One Mount
This document provides instructions for installing the Christie One Mount/Plus and optional
accessories to mount Christie projectors to a ceiling or truss:
Safety precautions
Tools required
• 5mm hex key
• 3mm hex key
Parts Lists
Christie One Mount (P/N: 108-506102-01)
Christie One Mount Plus (P/N: 140-117100-01)
Christie One Mount Extender Rod (P/N: 121-125109-01)
Christie One Mount Rigging Kit (P/N: 121-126100-01)
Failure to comply with these safety precautions results in death or serious injury.
• ELECTRICAL SHOCK HAZARD! Always turn off, disconnect, and disengage all power
sources to the projector before servicing.
• Christie One Mount maximum projector weight limit is 25 kg (55 lbs).
• Christie One Mount Plus maximum projector weight limit is 45 kg (99 lbs).
• Mount the ceiling plate to a structure capable of handling the combined maximum weight
of the projector and the mount. The installation must meet local building codes. Attach
using all four holes (mounting screws/bolts are not included with the mount).
Failure to comply with these safety precautions may result in serious injury, or even death.
• Only qualified Christie service technicians are permitted to open any enclosure on the
projector and only if the all power sources have been fully disconnected.
• At least two qualified people should perform the installation procedure. Personal injury
and/or property damage can result from dropping or mishandling the projector.
• If mounting to ceiling studs, make sure that the mounting screws are anchored into the
center of the ceiling studs. Use of an edge-to-edge stud finder is recommended.
• Be aware of the mounting environment. If drilling and/or cutting into the mounting
surface, always make sure that no electrical wires are in the wall.
• Do not install near sources of high heat. Do not install on a structure prone to vibration,
movement, or chance of impact.
To Next Page
Need help?
General
