Why is the measurement of V, I poor in my Chroma 61502?
Poor measurement of V, I in Chroma AC Power Distribution is caused by aging of components, which results in deviation of characteristics. Periodic calibration is required.
General| Operating Temperature | 0°C to 40°C |
|---|---|
| Output Current | 16A |
| Control Interface | Ethernet, RS-232 |
| Crest Factor | 3 |
| Maximum Current per Phase | 16A |
| Circuit Breaker | 16A per phase |
Step-by-step guide for powering on and initial self-test.
Understanding the primary display for settings and measurements.
Procedure for calibrating output voltage and measurement accuracy.
Procedure for calibrating output current and measurement accuracy.
Essential safety guidelines and hazard symbol explanations.
Procedures for self-testing and resolving common issues.
To Next Page
