Why is the measurement of V, I poor in my Chroma 61504 AC Power Distribution?
Poor measurement of V, I in Chroma AC Power Distribution is caused by aging of components, which results in deviation of characteristics. Periodic calibration is required.
General| Brand | Chroma |
|---|---|
| Model | 61504 |
| Category | AC Power Distribution |
| Language | English |
Lists the detailed technical specifications for the AC source models.
Instructions on how to connect the power cord to the AC source.
Describes how to use the keypad and Rotary Pulse Generator for programming.
Configuration settings for voltage limits, output relay, buzzer, datalock, etc.
Settings related to remote inhibit, external voltage, waveform generation, and communication.
Settings for coupling modes, output degree, impedance, phase modes, and parallel operation.
Entry point for calibration procedures after password authentication.
Steps to calibrate output voltage and measurement accuracy.
Procedure for calibrating current measurement accuracy.
Performing harmonic analysis, calculating THD, fundamental, and harmonic orders.
Creating custom waveforms by composing harmonic components.
Describes the power-on self-test items and error codes.
Lists common problems, their reasons, and suggested corrective actions.
To Next Page
