Chroma 62012P-100-50 - Setting RUN COUNT

Programmable DC Power Supply 62000P Series Operating & Programming Manual
PROG #1
PROG CHAIN NO = 3
SEQ 1_1 ~ SEQ 1_10
PROG #2
PROG CHAIN NO = 0
SEQ 2_1 ~ SEQ 2_10
PROG #3
PROG CHAIN NO = 4
SEQ 3_1 ~ SEQ 3_10
PROG #4
PROG CHAIN NO = 6
SEQ 4_1 ~ SEQ 4_10
PROG #5
PROG CHAIN NO = 0
SEQ 5_1 ~ SEQ 5_10
PROG #6
PROG CHAIN NO = 0
SEQ 6_1 ~ SEQ 6_10
PROG #7
PROG CHAIN NO = 0
SEQ 7_1 ~ SEQ 7_10
PROG #8
PROG CHAIN NO = 0
SEQ 8_1 ~ SEQ 8_10
PROG #9
PROG CHAIN NO = 0
SEQ 9_1 ~ SEQ 9_10
PROG #10
PROG CHAIN NO = 0
SEQ 10_1 ~ SEQ 10_10
START
Figure 4-6
3. Press “
ENTER
” to confirm.
4. Press “
EXIT
” to return to MAIN PAGE.
4.1.1.3 Setting RUN COUNT
1. Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-3 (3)
shows.
2. Use the numeric (
0
~
9
) keys or “Rotary” ( ) knob to set the value.
Each PROGRAM has a RUN CONUT that sets the execution number. Following table
lists the RUN COUNT range:
4-6