Need help?Do you have a question about the Chrysler 1956 Imperial and is the answer not in the manual?
General| Brand | Chrysler |
|---|---|
| Model | 1956 Imperial |
| Category | Automobile |
| Language | English |
Procedure for measuring and adjusting front spring heights based on car model.
Description of how brake shoes are held in position by return springs.
Steps for disassembling the rear brake system, including shoe removal.
Procedure for assembling the wheel cylinder and support plate for rear brakes.
Procedure for assembling the front brake system components.
Importance of brake shoe alignment for maximum braking and how to check it.
Step-by-step guide for removing the power brake unit from the vehicle.
Procedures for testing battery condition through visual inspection and specific gravity.
Procedure for testing battery voltage and cell readings.
Procedure to test starter circuit resistance and current draw.
Procedure for setting and testing the voltage regulator's output.
Procedure for testing and adjusting the current regulator.
Procedure for testing the generator's cut-out relay function.
Procedure for aligning distributor contact points for proper ignition timing.
Procedure for testing headlight voltage with lights burning.
Description of power window, seat lift, and windshield wiper circuits.
Explanation of how the push button control unit operates and selects ranges.
Procedure for removing and installing the radio and speaker.
Overview of the Instant Heat Conditionaire heater and its sub-assemblies.
Procedure for removal of the thermostat assembly from the heater.
Procedure for removal and installation of the ignition unit.
Procedure for removal and disassembly of the burner and exchanger assembly.
Procedure for removal and disassembly of the heater burner blower and fuel pump.
Instructions for assembling the power unit components.
Procedure for removal and installation of the compressor seal assembly.
Procedure for replacing the valve plate assembly in the compressor.
Procedure for removing and installing the magnetic clutch assembly.
Procedure for testing the magnetic clutch field coil for grounds.
Explanation of the power cylinder and reactionary linkage operation.
Detailed steps for disassembling the power unit.
To Next Page