Need help?Do you have a question about the Chrysler 1956 New Yorker and is the answer not in the manual?
General| Brand | Chrysler |
|---|---|
| Model | 1956 New Yorker |
| Category | Automobile |
| Language | English |
Steps for removing key rear brake components.
Procedures for disassembling and assembling front brakes.
Procedures for removing the piston type power unit and its pedal linkage.
Specifications for battery, starter motor, and generator components.
Details on generator regulator model, resistors, and voltage winding.
Specifications for distributor model, contact gap, dwell, and capacity.
Methods for testing the vehicle's battery performance.
Procedures for testing battery voltage and charging batteries.
Tests for circuit resistance and starter current draw.
Procedure for setting the voltage regulator voltage output.
Steps for testing the current regulator's output.
Procedure for testing the generator's cut-out relay function.
Ignition coil testing, distributor types, and contact point alignment.
Testing ignition primary circuit for voltage drop.
Overview and servicing of power window, seat lift, and electric wiper systems.
Specifications for crankshaft type, bearings, and journals.
Details on bearing sizes, main bearing journals, and crankpin journals.
Specifications for connecting rod type, length, and weight.
Specifications for connecting rod bearings and camshaft components.
Specifications for camshaft journals, timing chain, tappets, and pistons.
Specifications for piston weight, length, pins, and rings.
Specifications for intake and exhaust valves, and valve springs.
Specifications for cylinder head and engine lubrication.
Specifications for fuel pump and carburetor components.
Details on kickdown piston, extension housing, valve body, and other components.
Procedures for removing, installing, and adjusting the cable assembly.
Adjusting cable backlash and removing the push button control unit.
Diagnosis and remedies for various push button operational problems.
Specifications for torque converter, stall speed, and shift points in M.P.H.
Procedures for removing and installing door handles, lock cylinders, and latches.
Steps for removing and installing front door glass with electric window lifts.
Capacities for vehicle fluids and recommended tire pressures.
Recommended engine oil viscosity based on atmospheric temperature.
Procedures for testing the heater system and its components.
Notes on servicing the air conditioning system and its components.
Lists serviceable compressor components and details the seal assembly replacement.
Procedures for valve plate assembly replacement and magnetic clutch description.
Steps for clutch assembly removal and testing the field coil.
Tests for shorted field coil and overall AC system performance.
Explains the operation of the power cylinder and its reactionary linkage.
Explains how the power unit applies, holds, and reaches full application.
Explains power unit operation when vacuum is absent.
Procedures for disassembling and assembling the power unit.
Procedures for testing brake system vacuum and hydraulic leakage.
Performing an operational test of the brake power unit.
To Next Page