Receiving A Call – Accept (And End)
• When an incoming call rings / is announced on uconnect™, press the Phone
button
.
• To end a call, press the Phone button
.
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice button .
• (After the BEEP), say “mute on” (or “mute off ”).
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice button
.
• (After the BEEP), say “transfer call”.
Changing The Volume
• Start a dialogue by pressing the Phone button
, then adjust the volume during
a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the uconnect™ system is speaking. Please note the volume setting for
uconnect™ is different than the audio system.
NOTE: To access the tutorial, press the uconnect™ hard-key. After the BEEP, say
“tutorial”. Press any hard-key or touch the display to cancel the tutorial.
VOICE RECOGNITION
• The Voice Recognition (VR) system allows you to control your AM, FM radio,
satellite radio, disc player, and a memo recorder. When you press the VR
button
, you will hear a beep. The beep is your signal to give a command. If you
do not say a command within a few seconds, the system will present you with a list
of options. If you ever wish to interrupt the system while it lists options, press the
VR button
, listen for the BEEP, and say your command.
• Please refer to uconnect™ tunes in the uconnect™ User’s Manual on the DVD for
further details.
Changing The Volume
• Start a dialogue by pressing the VR button , then say a command (e.g.,
“tutorial”).
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the Voice Recognition system is speaking. Please note the volume
setting for Voice Recognition is different than the audio system.
33
ELECTRONICS
To Next Page
Loading...
Need help?
General
