Chrysler Cruiser PT 2010 - Front Fog Lamps - if Equipped; Rear Tail, Stop and Turn Signal Lamps

3. Rotate the socket to the left one-quarter turn, and
replace the bulb.
Front Fog Lamps – If Equipped
1. Remove the fasteners attaching the lower splash
shield to gain access to the fog lamp.
2. Twist and remove the bulb from the fog lamp housing.
3. Disconnect the electrical connector and replace bulb.
Rear Tail, Stop and Turn Signal Lamps
1. Remove the screw attaching the tail lamp housing and
remove the housing from the vehicle.
2. Twist the bulb socket one–quarter turn to remove it
from the housing.
3. Pull the bulb out of the socket and replace.
7
MAINTAINING YOUR VEHICLE 345