• Many of these reasons are displayed as a
STOP/START message in the instrument cluster
display on the STOP/START screen. The system
must be in the “STOP/ START READY” state to
autostop. To access the STOP/START section of
the instrument cluster display, use the display con-
trols. Refer to the “Starting and Operating” section
of your Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents) for a complete list of possible
events in which the engine does not autostop.
How do I know I am in an autostop?
• The engine will shut down, the ta-
chometer will move to the zero posi-
tion and the STOP/START telltale
will illuminate in the instrument
cluster.
How do I start the engine while in an autostop?
• While in a forward gear, the engine will start when
the brake pedal is released or the throttle pedal is
depressed. The transmission will automatically re-
engage upon engine restart.
Automatic High Beam — If
Equipped
This system automatically controls the operation of
the headlamp high beams as oncoming vehicles ap-
proach.
• The Automatic High Beam Headlamp Control can
be turned on or off using the Uconnect System.
• Push the turn signal lever away from you.
• With the headlight switch in the “AUTO” position,
the high beams are controlled automatically.
• Pull the turn signal lever toward you to manually
deactivate the system.
• To improve system recognition of crossing traffic,
and to limit use in a residential area, the vehicle
must be moving at a speed greater than 20 mph
(32 km/h) before the Automatic High Beam Mod-
ule (AHBM) begins requesting high beam
activation.
STOP/START Message
LIGHTS
To Next Page
Loading...
