Chrysler PACIFICA 2024 - LINK YOUR GARAGE DOOR; Garage Door Opener

Garage Door Opener
Push and hold the two outside HomeLink® buttons for 20 seconds until the
orange indicator flashes. An individual channel cannot be erased.
TO ERASE ALL SET CHANNELS:
22
11
While the car is ON, hold the handheld garage door transmitter 1-3 inches
from the HomeLink® button you want to program in the vehicle.
Push and hold both the HomeLink®
button being programmed and the
button on the garage door transmitter.
NEED ASSISTANCE?

Scan For
HomeLink®
Video
55
4 4
33
For Non-Rolling Code garage door openers, watch for the indicator
light to go constant.
For Rolling Code garage door openers, watch for the indicator light
to go from a slow blink to blinking rapidly.
If the programming was successful, your garage door should
open and close with your chosen HomeLink® button.
ROLLING OR NONROLLING?
Check your garage door opener motor in your garage for a
“LEARN” or “TRAIN” button by the hanging antenna. If you have
one of these, you have a Rolling Code garage door opener.
??
For Rolling Code garage door openers only, firmly push and release the
“LEARN” or “TRAIN” button on your garage door opener motor in your
garage, then push the HomeLink® button in your vehicle three times
(holding the button for two seconds each time).
LINK YOUR GARAGE DOOR