Tire Chains
Use only compact chains, that meet SAE type
“Class S” specifications. Chains must be the
proper size for the tire, as recommended by the
chain manufacturer. For other traction aids, con-
tact your dealer.
CAUTION!
To avoid damage to your vehicles tires, observe
the following precautions:
• Install chains on front wheels as tightly as
possible and then retighten after driving
about 1 km.
• Do not exceed 50 km/h (31 mph).
• Drive cautiously and avoid severe turns and
large bumps, especially with a loaded ve-
hicle.
NOTE:
In order to avoid damage to tires, chains, and
your vehicle do not drive for a prolonged
period of time on dry pavement. Observe the
tire chain manufacturer’s instructions on
method of installation, operating speed, and
conditions for usage.
Always use the lower suggested operating
speed if both the chain manufacturer and
Chrysler International suggest a maximum
speed. This notice applies to all chain traction
devices, including link and cable (radial)
chains.
CAUTION!
Because of restricted chain clearance between
tires and other suspension components, it is
important that only chains in good condition are
used. Broken chains can cause serious vehicle
damage. Stop the vehicle immediately if noise
occurs that could indicate chain breakage. Re-
move the damaged parts of the chain before
further use.
Snow Tires
Some areas require the use of snow tires during
winter. Your original equipment tires are of the all
season type and satisfy this requirement. If you
should want snow tires, select tires equivalent in
size and type to the original equipment tires.
Tire Rotation Recommendations
Tires on the front and rear axles of vehicles
operate at different loads and perform different
steering, driving, and braking functions. For these
reasons, they wear at unequal rates, and tend to
develop irregular wear patterns.
These effects can be reduced by timely rotation of
tires. The benefits of rotation are especially worth-
while with aggressive tread designs such as those
on all season type tires. Rotation will increase
tread life, help to maintain mud, snow, and wet
traction levels, and contribute to a smooth, quiet
ride.
Rotate your tires at intervals of 12 000 km (7,500
miles) if you are following Maintenance Schedule
“A” and at 9 600 km (6,000 miles) if you are
following Maintenance Schedule “B”. More fre-
quent rotation is permissible if desired. The cause
of any unusual wear should be corrected prior to
rotation being performed.
The suggested rotation method is the “forward-
cross” shown in the following diagram.
102
To Next Page
Loading...
