General Information
Transmitter and receivers operate on a carrier
frequency of 433.92 MHz as required by EEC
regulations. These devices must be certified to
conform to specific regulations in each individual
country. Two sets of regulations are involved: ETS
(European Telecommunication Standard)
300–220, which most countries use, and German
BZT federal regulation 225Z125, which is based
on ETC 300–220 but has additional unique re-
quirements. Operation is subject to the following
two conditions:
• This device may not cause harmful interfer-
ence.
• This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
If your Remote Lock Control fails to operate from a
normal distance, check for these two conditions.
1. Weak batteries in transmitter. The expected life
of the battery is a minimum of three years.
2. Closeness to a radio transmitter such as a
radio station tower, airport transmitter, and some
mobile or CB radios.
Transmitter Battery Service
The recommended replacement battery for the
five button transmitter is the 2032 and the two
button transmitter uses two 2016 batteries.
NOTE:
Do not touch the battery terminals that are on
the back housing of the transmitter or the
printed circuit board.
Two Button Transmitter
1. With the transmitter buttons facing down, use a
thin coin to pry the two halves of the transmitter
apart. Make sure not to damage the rubber gasket
during removal.
2. Remove and replace the batteries. Avoid
touching the new batteries with your fingers. Skin
oils may cause battery deterioration. If you touch
a battery, clean it with rubbing alcohol.
3. To reassemble the transmitter case snap two
halves together. Make sure there is an even “gap”
between the two halves. Test transmitter opera-
tion.
Five Button Transmitter
1. With the transmitter buttons facing down, use a
thin coin to pry the two halves of the transmitter
apart. Make sure not to damage the rubber gasket
during removal. Press the LOCK button to raise
the printed circut board/gasket assembly from the
button side half of the housing and allow the 2032
battery to be slid out of its holder.
Two Button Transmitter
Five Button Transmitter
17
To Next Page
Loading...
