Overrunning Clutch
The fluid should be maintained at the bottom of
the filler hole opening. If it becomes necessary to
add or replace the fluid, use only ATF+4 Type
9602 Mopar Automatic Transmission Fluid. To
assure performance, it is important that the proper
lubricant be used.
Rear Carrier
The fluid should be maintained at the bottom of
the filler hole opening. if it becomes necessary to
add or replace the fluid, Chrysler International
recommends that Multipurpose Gear Oil SAE
80W-90 meeting API specification GL-5 should be
used.
Fluid Changes
The fluid should be changed as follows:
Normal Usage No Service Required
Severe Usage
Power Transfer Unit 24 000 km (15,000
miles)
Overrunning Clutch 36 000 km (22,500
miles)
Rear Carrier 36 000 km (22,500
miles)
Severe Usage is defined as:
1. More than 50% of vehicle operation in stop and
go traffic where vehicle is driven regularly for more
than 45 minutes of continuous operation, such as
in heavy city or in construction zone traffic,
2. Police, taxi, limousine, commercial type opera-
tion, or trailer towing where the vehicle driven
regularly for more than 45 minutes of continuous
operation.
Front And Rear Wheel Bearings
Front and rear wheel bearings are permanently
sealed. No regular maintenance is required for
these components.
Appearance Care and Protection from
Corrosion
Protection of Body and Paint from Corrosion
Vehicle body care requirements vary according to
geographic locations and usage. Chemicals that
make roads passable in snow and ice, and those
that are sprayed on trees and road surfaces
during other seasons, are highly corrosive to the
metal in your vehicle. Outside parking, which
exposes your vehicle to airborne contaminants,
road surfaces on which the vehicle is operated,
extreme hot or cold weather and other extreme
conditions will have an adverse effect on paint,
metal trim, and underbody protection.
The following maintenance recommendations will
enable you to obtain maximum benefit from the
corrosion resistance built into your vehicle.
What Causes Corrosion?
Corrosion is the result of deterioration or removal
of paint and protective coatings from your vehicle.
The most common causes are:
• Road salt, dirt and moisture accumulation.
• Stone and gravel impact.
• Insects, tree sap and tar.
• Salt in the air near sea-coast localities.
• Atmospheric fallout/industrial pollutants.
Washing
• Wash your vehicle regularly. Always wash your
vehicle in the shade using a mild car wash
soap, and rinse the panels completely with
clear water.
• If insects, tar or other similar deposits have
accumulated on your vehicle, wash it as soon
as possible.
• Use Mopar auto polish to remove road film and
stains and to polish your vehicle. Take care
never to scratch the paint.
• Avoid using abrasive compounds and power
buffing that may diminish the gloss or thin out
the paint finish.
142
To Next Page
Loading...
