Need help?Do you have a question about the Chuango WS-280 and is the answer not in the manual?
Explains the meaning of different LED states for the siren's operation modes like arming, disarming, and post-alarm.
Details the components and connection points visible on the rear of the siren, including mounting holes and tamper switch.
Guides users on how to set alarming volume and duration using jumpers on the PCB board.
Illustrates how to set the siren's alarm volume to HIGH, MUTE, or LOW using jumper settings.
Shows how to configure the duration of the siren's alarm to 5 MIN, 2 MIN, or 30S via jumpers.
Step-by-step guide on pairing the siren with a wireless control panel for operation.
Instructions on how to disconnect the siren from a previously connected control panel.
Details the purpose and connection of wired terminals for power input and sensors.
Provides a step-by-step guide for mounting the siren, including positioning and securing.
Explains how to enter connection status via remote control to pair new accessories without dismounting.
General| Connectivity | Wireless |
|---|---|
| Frequency | 433MHz |
| Radio Frequency | 433MHz |
| Housing Material | ABS plastic |
| Operating Condition | Indoor |
| Type | Wireless |
| Sensors | Door/Window Sensor |
| Power Supply | Backup Battery |
| Alarm Current | <300mA |
| Expandable | Yes |
| Operating Temperature | -10°C to +55°C |
| Compatibility | Chuango Sensors and Accessories |
To Next Page
