500-3650E rev1.3
Welcome
Alarm
Status Admin Reference
13
To view the armed state of the system, log in
from the “Enter ID:”
screen. If all areas
are ON this screen
will display:
If one or some areas
are armed this screen
will display:
If a trouble condition occurred since the last
arming, this screen will display on disarming…
When this screen is
acknowledged (Ack)
the problem condition
can only be seen by checking system Status. If
fault conditions are present, than arrangements
should be made to have them corrected.
Remote Reset
For customers who would rather reset the
ACPO alarm themselves, instead of a
service/engineer person attending and doing
it.
• When the ACPO alarm occurs, the LCD
keypad screen will display a 6 digit code.
• The customer notifies the monitoring
station with this number.
• The monitoring station enters the number
in this program’s “Customer Input:” box
and generates a response 6 digit number.
• The monitoring station gives this response
number to the customer who enters it into
the keypad and can reset the ACPO
alarm.
All on Menus ►
↓Off ↓Stay
Partially Armed ►
↓Off ↓Stay
System Fault or
Tampered ↓Ack
To Next Page
Loading...
Need help?
General
