Alarm
Mode
Visual
Indications
Audible
Indications
Smoke or Fire
detected
Living Area
Model P3010L
Part No. 135986
3 blinks synchronized with
audible alarm
3 long beeps(ISO8201),
repeating
Bedroom with Voice
Model P3010B
Part No. 135987
3 blinks synchronized with
audible alarm
3 long beeps(ISO8201),
repeating with voice “Fire-
Fire” announced
Hallway with Emergency
Safety Light
Model P3010H
Part No. 135988
3 blinks synchronized with
audible alarm & amber light
illuminated
3 long beeps(ISO8201),
repeating
Alarm
Mode
Visual
Indications
Audible
Indications
Normal
Operation
All Blink once every 60 sec-
onds
None LED will flash every 60 seconds for
10 minutes following power on or
reset. After initial 10 minutes, LED
will flash once every
10 minutes
Test/Hush
Button Press
All Blink with each alarm
pattern
Two sets of 3 long
beeps
Test/Hush button press will ini-
tiate test sequence
P3010B
135987
Voice “Fire-Fire”
announced
“Bedroom” smoke alarm with
voice
Model P3010B
Part No. 135987
Smoke Alarm
Hush
All Blink once every 10
seconds
None (smoke alarm
silenced)
Alarm hush feature silences
smoke alarm for approx. 10
minutes. See page 13 for
additional instructions.
Low Battery All Blink once every 30
seconds
Chirp every 60 sec-
onds
Chirp every 60 seconds
P3010B
135987
Voice “Low Battery”
announced
“Bedroom” smoke alarm with voice
Model P3010B
Part No. 135987
Fault Mode All Fault code (2-12 flashes
every 30 seconds)
Chirp every 30
seconds
Remove, turn off and replace
alarm
End of Unit
Life*
All 2 blinks every 30 sec-
onds
2 chirps every 30
seconds
Remove, turn off and replace
alarm
Operational
Mode
Visual
Indications
Audible
Indications
Note:
If you require further information please contact Service on 1800 654 435 or visit our website at www.quell.com.au.
Model
Model
* End of life hush feature. Silences end of life indication 3 days at a time for a maximum of 30 days.
End of Life Hush™
This alarm has End of Life Hush™ which allows you to silence the trouble chirp for three days giving
you extra time to replace the unit at a more convenient time.
To activate, press the Test/Hush button. While in the End of Life Hush™ mode, the alarm will still
detect Smoke.
The End of Life signal can be reset a maximum of 10 times for a total of 30 days. After 10 resets the
end of life signal can no longer be silenced and the alarm must be replaced immediately.
To Next Page
Loading...
Need help?
General
