5. Alarm Visual and Audible Indicators
OPERATION: The alarm is operating once it is activated and testing is complete.
When products of combustion are sensed is detected the unit sounds a loud 85db
pulsating alarm until the air is cleared.
Warning: Due to the loudness (85 decibels) of the alarm, always stand an
armʼs length (about 2.5 feet) away from the unit or use ear protection when
testing.
TESTING: Test your alarm by pressing the test button until the unit chirps, then release
the test button. The unit will then emit 2 sets of three slow beeps.
Quell® Worry-Free “Bedroom” smoke alarm model P3010B (135987) will also
issue a voice prompt stating “Fire Fire”.
Quell® Worry-Free “Hallway” smoke alarm model P3010H (135988) will briefly
illuminate the amber safety light.
The alarm will sound if the electronic circuitry, horn and battery are working. If the
alarm does not sound, the unit must be replaced.
Weekly testing is required to ensure proper operation. Erratic or low volume sound
(or no sound) coming from your alarm may indicate a defective alarm and it should be
returned for service. See deactivation section to determine how to prepare the unit for
shipment or disposal.
Warning: DO NOT use an open flame to test your alarm, you could damage
the alarm or ignite combustible materials and start a structure fire.
4. OPERATION AND TESTING
To Next Page
Loading...
Need help?
General
