CONTENTS
This alarm detects products of combustion using photo-
electric technology. This alarm is acceptable for use in all
residential applications where smoke alarms are required.
After ten (10) years of cumulative power up, this unit will
“chirp” two times every 30 seconds. This is an “opera-
tional end of life” feature which will indicate that it is time
to replace the alarm.
To help identify the date to replace the unit, a label has
been affixed to the side of the alarm. Write the “Replace
by” date (10 years from initial power up) in permanent
marker on the label prior to installing the unit.
Product Features and Specifications:
Temperature: Operating Range: 0°C to 40°C
Humidity: Operating range: up to 93% non-condensing
Audible Alarm: 85+ dB at 3 metres @ 3.4±0.5 KHz pulsing alarm
Smoke Sensor: Photoelectric
1 — WHAT TO DO WHEN THE ALARM SOUNDS (SMOKE
ALARM ACTIVATION)
2 — LIMITATIONS OF SMOKE ALARMS
3 — INSTALLATION INSTRUCTIONS
4 — OPERATION AND TESTING
5 — VISUAL AND AUDIBLE INDICATIONS
6 — MINIMISE NUISANCE ALARMS
7 — BATTERY
8 — DEACTIVATION OF ALARM
9 — CLEANING
10 — GOOD SAFETY HABITS
11 — SERVICE
12 — WARRANTY
To Next Page
Loading...
Need help?
General
