Other function Keys :
Space+N : Toggle keyboard 6 KRO/NKRO (Default state 6KRO) .
Long press "Space" + "N" key and then plug in USB cable.
Space+B or FN+R SHIFT+R : To enter DFU(Device Firmware Upgrade)
mode .Long press "Space" + "B" or FN+R SHIFT+R and then plug
in USB cable until FN LED flash to enter tlöe DFU mode.
Space+L_CtrI or Caps : Exchange L Ctrl and Caps key function .
Long press "Space" and "L_ Ctrl" or "CAPS"and then plug in USB
cable to exchange two keys function.
Space+Backspace or M: Exchange Backspace or Mkey function .
Long press "Space" and "Backspace" or "M" and then plug in USB
cable to exchange two keys function.
Bluetooth RPairing Instructions:
Perform the following steps to pair this keyboard with your device(s).
1. This Bluetooth keyboard can be paired with up to three devices at
the same time. Power On keyboard . (Close to USB port is OFF,
Reverse direction is ON) .Press and hold the FN and Z / or FN and X /
or FN and C keys for 3-5 seconds. When Z/X/C starts flashing, the
keyboard is ready to connect.
2. Open the Bluetooth settings on your device and scan for available
devices.
Locate and select the " CIDOO V65 " entry.
3. Once the keyboard has connected to your device, the Z/X/C key
will cease
flashing, indicating that Bluetooth pairing was successful. Short
press "FN" and "Z" or "FN" and "X" or "FN" and "C" keys to
switch paired Bluetooth device.
FN+Space : Short press "FN" and "SPACE" key, will disconnect
Bluetooth mode, when you plug in USB cable, it turns to USB wired
mode priority.
To Next Page
Loading...
